26
Luggage Carrier
NOTE:
There are different sizes of clamps to fit all types of chairs and configurations. The carrier is
mounted to the frame or footrest tube on Rigid chairs and mounted on the footrest hangers or
extension tubes on Catalysts and Tilt chairs. If hangers have been omitted the carrier is mounted to
the vertical front frame tube. The image below shows a luggage carrier being installed on a chair
with a footrest extension. The installation is the same whether it is being installed on the frame or
footrest tubes.
1. Install luggage carrier fork (A) and clamp (B) by installing two screws (C) and barrel nut (D) through the
clamp and fork using two 4mm Allen wrenches.
2. Secure the clamp in the desired location by installing and tightening the screw (E) and nut (F) on the
backside of the clamp using a 5mm Allen wrench.
NOTE: The nut for the backside screw goes into a recess in the clamp. Ensure that nut stays in
place.
3. Repeat on opposite side.
Using the Luggage Carrier
1. Operating position for the luggage carrier is when the forks are folded down (See image below). The
max weight capacity is 55lbs.
2. When not in use, fold the luggage carrier up.
C
E
B
D
A
B
F
C
Folded Up
Operating Position
