©2017 Copyright Kappers Fabricating, Inc. All rights reserved
Page 2
WIRING INFORMATION
1. The battery location is under the seat.
2. We recommend mounting the contactor next to the battery
under the seat.
3. Use the wiring diagram in your winch manual to see how
the winch and
controllers
are wired.
4. Wire the red ignition wires from controllers to the red (+)
4. Attach the rear holes of the winch to the winch
mount (1) loosely using the hardware (B) provided
with your winch. Shown in Figure 5.
5. Set winch fairlead plate (2) into the in the opening
behind the front frame tubes over top of the winch
mount plate. Shown in Figure 6.
6. Attach the front holes of the winch through the two
plates loosely using the hardware provided with
your winch. Shown in Figure 7.
7. Bolt the roller fairlead to the front factory fairlead
location on the frame. By inserting the supplied
5/16 bolts (5) through the fairlead rollers into the
threaded frame holes and out the mounting holes.
Attach the 5/16 flange nut (6) to the bolts loosely.
Shown in Figures 7 & 8.
8. Tighten the rear frame bolts (3) as shown in figure
4, and front fairlead bolts (5) shown in figure 7.
Next tighten winch bolts on the top of the mount.
B
“Figure 5”
“Figure 6”
“Figure 7”
2
5
C
“Figure 8”
6
