18
VCP RF OUT CHANNEL SETTING
VIDEO CHANNEL SETTING
The built-in RF converter permits playback of video and
audio recordings through a TV receiver. The signals from the
RF converter are viewed through a vacant channel not used
for broadcasting in your viewing area.
The converter channel of all units is set to UHF channel 36
prior to shipment. Setting your TV receiver to UHF channel
36 may provide video playback. But, to obtain the best
possible reproduction on your TV receiver, accurate
adjustment to the RF converter output is required.
Œ
Turn on your TV.
´
Connect the ANT.IN jack on the rear panel of TV by using
the RF cable.
ˇ
Turn on the VCP to display the “PWR” indicator on the
panel.
¨
Press the “RF OUT CH” key on the remote control.
The “RF 36”indicator will blink on the panel and the test
pattern will be transmitted to the UHF 36 CH.
ˆ
Tune the UHF channel number by pressing the “TRK+/-” key.
Ø
Press the “RF OUT CH” key to set the changed UHF channel
number.
Œ
Turn on your TV.
´
Connect the ANT.IN jack on the rear panel of TV by using
the RF cable.
ˇ
Playback the tape.
¨
Tune the UHF channel 36.
If the sound is poor,set the RF OUT system by pressing the
“RF OUT SYS” key on the remote control, the system will be
rotated as follows.
VCP RF OUT SYSTEM SETTING
DVSS127W-GB/D 0.10.6 10:8 AM ˘
`
18
