14 V3050A SA Frequency Extender Getting Started Guide
Quick Start
Setup the Frequency Extender with the N9042B Signal Analyzer
Setup the Frequency Extender with the N9042B Signal Analyzer
1.
Verify host analyzer has software revision A.28.25 or later running in the
N9042B. On the analyzer press
System
,
Show System
. If an instrument
software update is required, the latest revision of the X-Series signal
analyzer software may be downloaded from:
http://www.keysight.com/find/xseries_software
2.
Attach the Baseplate to the V3050A using the four screws supplied in the
case. The screws go through the bottom of the base plate into the holes in
the bottom of the V3050A. A 2.0 mm hex wrench (not included in the
shipment) is required. Hand tighten the screws, do not over torque.
Figure 1-6
Base Plate Mounting
The signal analyzer (host) must have Option EXW (N9042B-EXW) installed.
The cable harness is not bi-directional and is marked with the proper
connections. The V3050A and N9042B must be warmed up for 30 minutes
prior to using.
