Keysight Technologies U3022AH10, User'S And Service Manual

Page: 83 / 92

U3022AH10 Troubleshooting the Test Set
Receiver Signal Path Insertion Loss Test
Connect the RF Flex cables to the Source OUT and CPLR THRU ports as indicated in Table 22
below. Check that the results are similar to Figure 63 below.
RF Path Description
Control Mode Entry
<address>.<data>
Insertion Loss
(Typical)
0.0
Figure 63
Path
#
16.0
Odd Ports
Path Components
Source OUT to CPLR THRU
1
2
1. Use the Source IN port associated with this group of test ports.
S10
S20
1
Even Ports
Source OUT CPLR THRU
Test Port
Group
RF Path Description
Control Mode Entry
<address>.<data>
Insertion Loss
(Typical)
0.0
Figure 63
Path
#
16.0
Odd Ports
Path Components
A IN to CPLR ARM
1
2
1. Use the Source IN port associated with this group of test ports.
S11
S21
1
Even Ports B IN to CPLR ARM
Test Port
Group
Connect the RF Flex cables to the receiver A/B IN and CPLR ARM ports indicated in Table 23
below and check that the results are similar to Figure 63 above.
Figure 63 Source and Receiver Bypass Path Response
Table 2 2
Source Bypass Signal Path Test Instructions
Table 2 3
Receiver Bypass Signal Path Test Instructions
U3022AH10 User's and Service Guide 83