Installation Note N9041-90008
5
Option EDC Upgrade
Installation Procedure
Analyzer Information
1.
Connect a power cord to the analyzer and turn on the analyzer.
2.
After the analyzer has completed turning on, press
System
,
Show System
.
Make note of the following information from the Show System screen:
Product Number _______________
Instrument S/W Revision _______________
3.
Check for the presence of the options listed below in the Show System screen. Put a check
mark after each option listed below that appears in the show System menu.
N9041B-CRW _______________
4.
Refer to the data in
above. Verify that the Product Number in
is appropriate for
the upgrade being installed:
If the Product Number in
is not appropriate for the Option EDC upgrade,
do not proceed
with the installation.
5.
Refer to the data in
above. If the instrument software is earlier than A.21.00, you must
upgrade to version A.21.00 or later. Keysight recommends that you update to the latest
instrument software version to ensure that you have the latest defect fixes. To check the latest
instrument software version, visit the following website:
http://www.keysight.com/find/N9041B_software
6.
Refer to the data in
above.
Verify that N9041B-CRW is checked (currently installed).
If N9041B-CRW is not installed, do not proceed with the installation of this kit. Option CRW, IF
Output, Ultra-Wide Bandwidth, is required to enable the rear panel Ext IF Out port.
For information on how to order Option CRW refer to the N9041B upgrade page at:
http://www.keysight.com\find\N9041B_upgrades
Kit to be Installed
Product Number (Step 2)
N9041BU-EDC
N9041B
