Keysight Technologies N5261A, User'S And Service Manual

Page: 19 / 99

Keysight N5261/62A User’s & Service Guide 13
Installation & System Operation
System Configurations
Table 1-4 and Table 1-5 document all supported configurations for
S-Parameter measurement capabilities for banded mm-wave systems using
the N5261A and N5262A test sets.
Capabilities: [C1]=pulse, [C2]=power control/RCVR leveling,
[C3]=SMC+phase, [C4]=SPM, [C5]=ITSMA
Table 1-4 PNA Based Configurations
PNA Model
(s)
PNA
Options
1
Test Set SRC
Connects
Ck
2
Cable Interface
Kit
Cable
Config.
Diag(s)
3
Capabilities and
Notes
N5222A
/B
200, 201 or
219
N5261A front n N5261A-102 A Y [C1,C2,C3,C4__]
N5262A front n N5262A-102 B V
[C1,C2__C4,__]
4
400, 401 or
419
N5261A front n N5261A-104 A Z [C1,C2,C3,C4__]
N5262A front n N5262A-104 B X [C1,C2,C3,C4,C5]
N5224A
/B
N5225A/B
200, 201 or
219
N5261A front n N5261A-112 A Y [C1,C2,C3,C4__]
N5262A front n N5262A-112 B V
[C1,C2__C4,__]
4
400, 401 or
419
N5261A front n N5261A-114 A Z [C1,C2,C3,C4__]
N5262A front n N5262A-114 B X [C1,C2,C3,C4,C5]
N5227A /B 200, 201 or
219
N5261A front n N5261A-112 A Y [C1,C2,C3,C4__]
rear y N5261A-112 E [C1,C2,C3,C4__]
N5262A front n N5262A-112 B V
[C1,C2__C4,__]
4
rear xxxxxx xxx config not available
400, 401 or
419
N5261A front n N5261A-114 A Z [C1,C2,C3,C4__]
rear y N5261A-114 E [C1,C2,C3,C4__]
N5262A front n N5262A-114 B X [C1,C2,C3,C4,C5]
rear y N5262A-114 F [C1,C2,C3,C4,C5]
5
1. All PNAs require Option 020. When an N5262A is used with a 2-Port PNA, Option 551 is required. For B models, software option
S93898B is required.
2. Condition of the Route PNA RF to rear panel “RF OUT” check box. n = not checked, y = check. Refer to step 9 on page 41 .
3. See Rear Panel Figure s 1-15 t o 1-2 0 (A-F) and Front Panel Figures 1-21 to 1-22 (V-Z) for th e configuration diagrams.
4.
Can only drive output on one port at a time in this configuration.
5. See Table 1-6 and Table 1-7 for Interface Cable Kits
.