18
Keysight AXIe Chassis Firmware Revision Guide
Appendix A
Appendix A
Example windows device manager PCIe enumeration of an AXIe chassis
shows a sample enumeration of an M9502A AXIe 2-slot chassis ESM
attached to an HP Z400 workstation. There are seven PCI bridge connections
identified on the ESM although only two are physically connected onto the
chassis backplane. In the figure no module cards are plugged into the chassis.
The network adapter on the ESM is identified at device entry #3.
ESM JTag switch settings
The JTag switch settings allow programming of the EEPROMs on the ESM by
either the shelf manager or through an external cable. These settings are
properly set at the factory. In the event of a device programming error, the
firmware status window may direct you to verify these switch settings. Refer to
the ESM module model number (right side of the ESM front panel). The
M9505-00130 ESM uses the two device switch setting. The M9505-00230 ESM
uses the four device switch setting. Refer to
for the correct switch
settings.
Figure 12
ESM Network Adapter
