Keysight Technologies E8740A-060, Startup Manual

Page: 8 / 35

8 Keysight E8740A-060 Start-up Guide
Equipment and Software CheckList
Requirements
Hardware
– N9041B UXA Signal Analyzer with the following options
– N9041B-5CXFrequency Range 3 Hz to 110 GHz
– N9041B-CRWProvides Ultra-Wide Bandwidth IF Output of up to 5 GHz
– DSOS804A High-Definition Oscilloscope
Software (preinstalled on the DSOS804A)
– 89600B VSA software
– 89601B/BN-BHQ Radar Pulse Analysis option
NOTE
For writing this guide, a test radar signal was generated. The modulation used
was FMCW (Frequency Modulated Continuous Wave) with pulse period of 1 to
2 m s. Both up and symmetrical FMCW was used.
A Keysight M8195A 65GSa/s Arbitrary Waveform Generator was used to
generate the radar signal at IF frequency. The IF signal was upconverted to 79
GHz with a Keysight N9029ACST-U12 compact up-converter. A E8257D PSG
was used as the LO source. The millimeter wave signal is filtered with a
bandpass filter and then amplified. Finally, it is connected to the N9041B RF2
connector with a WR12 to 1mm adaptor(SWC-121M-R1) from Sage Millimeter.