Keysight E8363B/C and E8364B/C Installation Note 5
General Information
Installation Procedure for the Upgrade Kit
Electrostatic Discharge Protection
Protection against electrostatic discharge (ESD) is essential while removing or
connecting cables or assemblies within the network analyzer.
Static electricity can build up on your body and can easily damage sensitive
internal circuit elements when discharged. Static discharges too small to be
felt can cause permanent damage. To prevent damage to the instrument:
—
always
wear a grounded wrist strap having a 1 M
Ω
resistor in series with it
when handling components and assemblies.
—
always
use a grounded, conductive table mat while working on the
instrument.
—
always
wear a heel strap when working in an area with a conductive floor. If
you are uncertain about the conductivity of your floor, wear a heel strap.
—
always
ground yourself before you clean, inspect, or make a connection to
a static-sensitive device or test port. You can, for example, grasp the
grounded outer shell of the test port or cable connector briefly.
shows a typical ESD protection setup using a grounded mat and wrist
strap. Refer to
“Tools and Equipment Required for the Installation” on page 6
for part numbers.
Figure 1
ESD Protection Setup
Overview of the Installation Procedure
