Installation Note N9020-90133
5
Installation Procedure
Installation Procedure
1.
. Locate and remove both strap handle assemblies
(1)
(N9020-60002). Each
handle is attached to the instrument case with two Torx 20 screws. Set aside the two strap
handle assemblies as they are no longer needed.
Figure 1
Strap Handle Removal
2.
Locate four strap handle hole plugs (
) and four screws (
) from the kit.
Install strap handle hole plugs and secure with screws. Torque to 21 in-lbs.
3.
Locate and remove the four key locks (5021-2840) from the four instrument feet located on the
bottom of the instrument. Set aside the four key locks as they are no longer needed.
4.
Locate and remove the four instrument feet
(2)
(5041-9167) located on the bottom of the
instrument. Set aside the four instrument feet as they are no longer needed.
5.
Locate and remove the four rear feet
(3)
(5041-9611). Each foot is attached with one Torx 20
screw and a washer. Set aside the four rear feet, the four screws and the four washers as they
are no longer needed.
