Keysight Technologies 86120B, User Manual

Page: 143 / 273

141
Programming Commands
Common Commands
average count.
*SRE
The *SRE (service request enable) command sets the bits in the service request
enable register.
Syntax *SRE <integer>
*SRE?
<integer> is defined as an integer mask from 0 to 255.
Description The service request enable register contains a mask value for the bits to be enabled
in the status byte register. A bit set to one in the service request enable register
enables the corresponding bit in the status byte register to generate a service request.
A zero disables the bit. The following table lists the bits in the service request enable
register and what they mask.
Signal-to-Noise Measurements:
measurement off
wavelength reference auto
reference (user) wavelength 1550 nm in vacuum
number of averages (count) 100
GPIB address not affected
Power-bar display on
Table 5-16. Conditions Set by *RST Reset (Continued)
Item Setting