Keysight Technologies 85054B, User'S And Service Manual

Page: 39 / 65

85054B 3-19
Use, Maintenance, and Care of the Devices
Connections
inch torque wrench to approximately 135 N-cm (12 in-lb). Refer to “Final Connection Using a
Torque Wrench” on page 3-16 for additional information.
4. Retighten the center conductor pull-back nut. It will “click” when it is tight.
Figure 3-9 Connecting the Sliding Load
How to Separate a Connection
To avoid lateral (bending) force on the connector mating plane surfaces, always support the
devices and connections.
CAUTION
Turn the connector nut, not the device body. Major damage to the center
conductor can occur if the device body is twisted.
1. Use an open-end wrench to prevent the device body from turning.
2. Use the torque wrench to loosen the connector nut.
3. Complete the separation by hand, turning only the connector nut.
4. Pull the connectors straight apart without twisting, rocking, or bending either of the
connectors.