Warning
l
Be sure to tighten the propeller manually, and ensure the installation of propellers is correct and tight.
l
Be sure to install the battery on the aircraft correctly and install the Micro-SD card
l
When 8 or more GPS satellites are found, the flight mode will switch to GPS mode, and the user can select one-key
takeoff or landing function.
l
When not in P mode, the aircraft will only maintain altitude, not position.
8. Flying
l
One-key Takeoff/Landing
When 8 or more GPS satellites are found, the flight mode will switch to GPS mode, and the user can select one-key
takeoff or landing function.
l
Manual Takeoff/Landing
Takeoff
St
art motor by pushing both control sticks to the inside ( or outside or left or right) corners. Release the sticks once the
1. Toggle the flight mode switch on your remote controller to the P mode. (P mode is positioning
mode; A mode is ALTHold mode, and F mode is function mode).
2. Turn on the remote controller.
3. Turn on the intelligent flight battery.
4. Ensure that the remote controller has connected to the aircraft. (The flight battery indicator on
remote controller displays the battery power normally, indicating the connection is successful. )
5. Turn on the mobile device Wi-Fi function, waiting for 30 seconds, and select GLINT2_
×××××
×
from Wi-Fi list. Input the default connection password: 12345678
6. Turn on GLINT 2.0 APP, tap
”
connect
”
to enter into the operation page, if it display
“
connect
successfully
”
on your screen, it means that the remote controller and mobile device connect
successfully.
7. Open GLINT 2.0 APP, tap
“
general setting
”
, and select
“
calibration
”
in the list.
8. Select
“
remote controller calibration
”
in calibration page, tap
”
calibrate
”
to enter into the remote
controller calibration.
9. Toggle remote controller stick, and follow on screen instructions within APP to calibrate.
10. Calibrate the compass, toggle S1 from 1 mode to 3 mode, and return back to 1 mode, rapidly
continuous toggle 5 times, or enter into the GLINT 2.0 APP
’
s operation page, tap the general setting
button, select compass calibration. If the aircraft status indicator blinks green rapidly, it means to
start the horizontal calibration of compass. Calibrate the compass as follows:
a)
Place the flight on a flat surface, rotate at a slowly speed taking the center of flight as axis, the
continuously flashes green turn into intermittent flashes.
b)
Place the aircraft nose down and rotate it vertically at a slowly speed, until the flashing of
green disappear.
C)
Complete calibration, if the aircraft status indicator goes back to normal flying status, it means
the compass calibration is successful.
11. Install the propellers. The positive propellers with CW characters should be mounted on positive
motors M1 and M2. The opposite propellers with CCW characters should be mounted on counter
motors M3 and M4.
Tap and slide to confirm automatic
takeoff. The aircraft will automatically
takeoff and hover at 1.2 meters.
Tap and slide to confirm automatic
landing. The aircraft will automatically
land and stop the motor.
