Installation Manual
Keynetics SentriKey® Installation Manual 2019 v3
8
Step
Instructions
Illustration
15.
b)
Let the lockbox drop down in the top slotted holes now,
and then install the bottom two screws. Tighten them
completely.
c)
Go back to the top screws and tighten them completely.
d)
Check that all four screws are tightened and firmly
secure.
WARNING: It is imperative when tightening the screws that
the process has not deformed or twisted the vault box. The
installation surface must be flat.
Reassemble Lockbox
16.
Reverse the disassembly process.
a)
Re-insert the metal Space Plate, ensuring it sits flush
and level.
b)
Re-insert the Latch Mechanism (if necessary, by
pushing the door latches in slightly to get them around
the latch supports. Use a small flat blade screwdriver to
push the latch in further, one side at a time.)
c)
Re-install the metal Security Plate and the single centre
bolt that retains the mechanism box.
Torque this fastener to 40.32 kg/cm (35 in/lbs).
17.
a)
Carefully redress the interconnect cable into the original
position. This step is critical as cable life can only be
maintained if the cable is replaced in its original location
and configuration. Ensure the protective braid has not
slipped down the interconnect cable. There is a notch
in the bottom of the latch mechanism and the key
holder for the cable to locate in.
b)
Re-install the grey Key Holder into the lid.
