9
IR Remote Control
Basic switching and troubleshooting may be achieved with the factory
remote control . Not all of the remote buttons are used .
Other advanced settings may be configured using TCP/IP or RS-232 and
via
Key Digital Management Software
™
Pro (KDMS
™
Pro)
downloaded
HERE.
Input Button
»
Used for video source switching
Auto Button
»
Used to enable auto switching mode .
Note: IR enabled Auto switching mode is disabled with manual switching .
Auto sensing can be fixed on via the serial TCP/IP RS-232 commands
Troubleshooting via IR
If you experience no picture on an output, activate troubleshooting mode to
fix hot plug detection related issues:
»
IR Button Sequence =
R3, R2, R1, X, Y
»
X = Output number (1-4 / 1-8) . Chosen using Device Select
numerical keypad
»
Y = 1 (On) / 0 (Off) . Chosen using Device Select numerical keypad
Extending IR and RS-232 Control
IR In
›
Maximum supported IR burst frequency is 55kHz .
›
The IR Sensor can be connected at the Rx unit only and receives signals from a 90° angle at up to 30 ft .
away .
»
Only the included IR sensors are compatible . Third-party IR Sensors may not be compatible .
IR Out
»
IR Out driving power: 5V with 32mA minimum current
IR Sensor / IN Pinout
Wire
Signal
Red
5V Power
White
IR Signal
Black
Ground
