Installation
WARNING:
Shock Hazard. May result in serious injury or death. Before physical mounting, turn OFF electrical
power to all circuit breakers feeding into the panel before installing or servicing this product.
STEP 1
Determine Product Location
1. Identify the location of each LS0 luminaire. Each segment box in a run will be labeled and numbered in the
order of the run layout. i.e., Segment #1 of 3, Segment #2 of 3, Segment #3 of 3 in a run with 3 segments.
2. Locate wiring holes for LS0 luminaire.
3. Determine location for X96 controller. Measure the length from the controller to the first luminaire and cut your
4-conductor cable to length. Since this a low-voltage wire, conduits are not required.
4. Ensure that there are enough adapters to complete your wiring. The X96 controller only comes with one
adapter to connect to the first LS0 segment. Extra adapters must be purchased separately.
STEP 2
Install Mounting Brackets
1. LS0 segments attach to the mounting brackets on the underside of the fixture. Determine location of mounting
brackets based on the center line of the segments.
2. Mount brackets to the surface with screws.
3. When screwing mounting brackets to the surface, do not over tighten the screws. The bracket should be snug
to the surface but the bracket should be able to rotate, and slide back and forth.
continued on next page
8 |
LS0
INSTALLATION GUIDE
P/N 3662562 Rev A
© 2021 Lutron Electronics Co., Inc. All rights reserved.
