• Select AUTO ADVANCE or MANUAL ADVANCE by pressing Enter to toggle selections.
• Auto Advance - In this mode, after the camera fires, the system will automatically ad-
vance to the next position in the movement
• Manual Advance - After firing the photo, you will hit Left or Right to move the camera
into the next/previous position in the move
• Select NEXT by pressing Enter.
• Select SNAP to trigger the camera and repeat for auto advance.
• Select SNAP to trigger the camera. Press the Left or Right arrow to move the camera
into the next/previous position for manual advance. Repeat.
MANUAL MOVE
• Select MANUAL MOVE to do a live move without programming.
• Set Speed: Select Speed by pressing ENTER. Adjust speed with UP/DOWN arrows and press
ENTER to set.
• Set Ramp: Select Ramp by pressing ENTER. Adjust ramp with UP/DOWN arrows and press
ENTER to set.
• Set Cal Limits: Select Cal Limits. Use controller to position motors to desired start position and
press ENTER to set BEGIN, then position motors to desired end position and press ENTER to set
END.
• Select START to begin Manual Move.
TURNTABLE
• Select TURNTABLE for continuous panning.
• The speed can be adjusted by pressing the Up or Down arrow at any time.
• Press the pan Left or Right arrow to start/stop panning.
SETTINGS
• Operation Mode – Takes you back to the Power Up Menu.
• Control Options – Inverts Controls depending on user preference
• Firmware Update – See “Updating Firmware” section
• Lash Compensation – Set up a pre-move to remove any lash in the system due to a change in
direction.
11
