14
Montage
8
Montage
8.1 Mounting attachment
•
To mount an attachment, the attachment and attachment tube on the drive unit must be clean and
well-lubricated (see Figure 8.1).
•
The coupling of the attachment and the receiving tube of the drive unit must be at the same height
to allow them to be pushed together. For this purpose, parking supports are available on some
attachments, where the appropriate height can be adjusted.
•
When assembling, it is important to note that the coupling driver (red plastic star) is located in one
of the two coupling halves.
•
Pull up the locking lever (Fig.8.1) and fold the locking lever upwards.
•
If the attachment of the attachment can not be pushed completely into the pick-up tube, then the
teeth of the two coupling halves may be opposite each other. By switching on the power take-off
and by slowly pulling on the starter cable of the engine, the drive shaft continues to rotate, allowing
the further drive in.
•
Lower the locking lever again and check that the locking pin is fully engaged.
Illustration 8.1
Clutch takeaway
Grease nipple
Locking lever
