Kersten B00005, Original Operating Manual

Page: 17 / 26

15
7 Maintenance
7.1 General Maintenance instructions
•
Check all safety related parts of the machine before use. Failure to do so can result in injury to
persons or damage to the machine.
•
oil change must be made according to the recommendations of the relevant motor manufacturer
.
•
Before each use, check the hydraulic connections for leaks.
•
Under high pressure, escaping fluids ( for example, hydraulic oil and diesel fuel ) can
penetrate the skin and cause serious injury! In the case of an accident, seek immediate
medical attention - risk of infection!
•
The hydraulic system is operated with biodegradable oil.
•
The machine must undergo regular maintenance.
•
Oil, fuel and filters must be kept seperate and disposed of properly.
•
When working on the electrical system, disconnect the battery.
•
Repair, maintenance, cleaning work and the correction of malfunctions must only take place if
the drive and the engine are switched off . remove Ignition key or spark plug cap ! After carrying
out this work all guards must be put back in place!
•
If the machine is transported in any other way than with the built-in drive , then this must be done
with the engine off!
•
Nuts and bolts must be checked regularly and tightened if necessary.
•
When carrying out electric welding work on the machine and on the attachment, disconnect the
alternator and the battery!
•
Only use original spare parts from the manufacturer !
•
After the first 5 hours of operation , check that all screw and bolt connections are tight.
•
Oil or grease all moving parts regularly.
•
Check the hydraulic connections for the first time after 5 hours of operation , tighten if necessary.
In case of a leak, if first tightening does not succeed.
Remove the hydraulic coupling completely, clean it and put it back on, ensuring it is tight.
7.2 Daily Maintenance
•
Before each use check the wear of all safety devices and moving parts.
•
Check the Hydraulic oil level before each use. Do this by unscrewing the cap and checking the
level on the dipstick.
•
Check the engine oi level and the cleanliness of the air filter. (See the operators manual from
the engine manufacturer for instructions.
•
Before and during use , particularly when mowing , check the protective grille for the suction of
cooling air is working and free from dirt and plant parts . Uninterrupted operation with a clogged
cooling system causes the engine to heat up and may cause damage
•
Clean the engine with a brush or compressed air.
•
Check the hydraulic connections and hoses.
•
Check the air pressure in the tyres.
•
Perform a test run before each use.
•
Clean the machine after each use.