TEFC_A-BA-e-2110
19
•
Prepare the required adjustment weight, see chapter 1.
Whenever possible, adjust using the adjustment weight with the weight simi-
lar to the maximum load of the scale (the adjustment weight is recommend-
ed, see chapter 1). The adjustment may also be carried out using weights
with other nominal values or tolerance classes, but this is not optimal from
the measurement technique perspective. The adjustment weight precision
must correspond to the interval [
d
] of the scale, though preferably it should be
a bit higher. For information concerning reference weights, see online at:
http://www.kern-sohn.com
•
Ensure stable environmental conditions. The heating time is required for the
stabilization (see chapter 1).
•
Ensure there are no objects on the scale plate.
What to do:
Switch the scale off.
With
TOL
pressed, switch the scale on using
ON/OFF
. During the autotest, press
TOL
and hold it for 10 s until <
> is displayed.
If required, use
TARE
to change the interval (
d
),
you can choose from 1
d
, 2
d
, 5
d
, 10
d
, 20
d
, 50
d
.
Confirm by pressing
TOL
, <
> will be displayed.
If required, use
TARE
to change the number of decimal places,
you can choose from 0, 0.0, 0.00, 0.000, 0.0000.
Confirm by pressing
TOL
, <
> will be displayed.
Press
TARE
, the maximum load (
Max
) will be displayed. Red LED above PCS
will be lit.
If required, change the value using
TARE
and
ZERO
(Entering a value in the
numerical form, see chapter 3.2.1).
Confirm by pressing
TOL
, <
> will be displayed.
Ensure there are no objects on the scale plate.
Once the stability check is completed successfully (red LED above
is lit),
confirm by pressing
TOL
, <
> is displayed.
Place the adjustment weight and confirm by pressing
TARE
.
The weight of the last used adjustment weight will be displayed. If required,
change the value using
TARE
and
ZERO
(Entering a value in the numerical form,
see chapter 3.2.1).
Confirm by pressing
TOL
.
Wait until <
> is displayed.
After the successful adjustment, the scale will switch to the weighing mode again
automatically.
If there is any adjustment error or if an incorrect adjustment weight is used, the
error message is displayed. Repeat the adjustment process.
Remove the adjustment weight.
