Wirnet iBTS
Document title : Installation and
Maintenance Manual
Version : 2.0
Author : SNI
Date : 04/12/2018
Classification
This document is the strict property of Kerlink and shall not be either copied nor sent without express
written authorization of Kerlink
Internal Use
Kerlink m2m technologies reserved rights
Confidential
Kerlink – 1 rue Jacqueline Auriol – 35235 THORIGNÉ-FOUILLARD
Page 187 / 221
Strict confidential
A specific crimping tool is required to perform the operation.
Figure 134 : Earthing of the outdoor Ethernet surge protection
Note 1:
the earthing cables are not provided by KERLINK
Note 2:
the earthing cables characteristics are detailed in §1.8.4.2.
4.6.1.6
Earthing of the outdoor PoE injector
On the outdoor PoE injector, the earthing connection is completed through a dedicated
earthing bolt and two nuts.
The earthing connection on the cable is completed through a ring terminal. A specific
crimping tool is required to perform the operation. The earthing cable must be crimped
inside this ring terminal.
The ring terminal is inserted between the two nuts as follows:
Figure 135 : Earthing of the outdoor PoE injector
Note 1:
the earthing cables are not provided by KERLINK
Note 2:
the earthing cables characteristics are detailed in §1.8.4.2.
Earthing screw
Earthing cable
