KEPCO KFD 6-25-28W, Operator'S Manual

Page: 4 / 28

ii
KFD 6-25-28W/060801
LIST OF FIGURES
FIGURE TITLE PAGE
1 Test Setup For Output Voltage And Efficiency Measurements For The DC to DC Converter ................ 11
2 Test Setup for the Input Reflected Ripple for the Single Output KFD DC To DC Converter................... 12
3 Mechanical Outline Drawing of the Single Output KFD DC to DC Converter .......................................... 13
4 Remote On/Off Wiring Configuration for the Single Output KFD DC to DC Converter ............................ 14
5 wiring configuration for redundant parallel operation of the KFD DC to DC Converter ............................ 15
6 Circuit Configuration for Single KFD DC to DC Converter Remote Sense Operation.............................. 16
7 (Top) KFD DC to DC Converter Circuit Configuration for R
Trim Down
,
to Decrease Voltage Setpoint............................................................................................................... 17
8 (Bottom) KFD DC to DC Converter Circuit Configuration for R
Trim Up
,
to Increase Voltage Setpoint ................................................................................................................. 17
9 Heat Sinks for Vertical Orientation - Kepco Model KFD-02 and the Kepco Model KFD-04 .................... 18
10 Heat sinks for Horizontal Orientation - Kepco Model KFD-01 and the Kepco Model KFD-03.................. 19
11 Forced Convection Derating, Power Dissipation Versus Local Ambient Temperature ........................... 20
12 Heat Sink Derating Curves, Natural Convection, Fins Oriented Along the Width .................................... 21
13 Heat Sink Derating Curves, Natural Convection, Fins Oriented Along the Length .................................. 22
14 Heat Sink Resistance Curves for Fins Oriented Along Vertical and Horizontal directions ....................... 23
15 Power Dissipation Versus Output Load for Three Different Input Voltages ............................................. 24
LIST OF TABLES
TABLE TITLE PAGE
1 Input Specifications .................................................................................................................................... 1
2 Output Response for the KFD Unit ............................................................................................................. 2
3 Dynamic Response for the KFD UniT ....................................................................................................... 2
4 Output Specifications ................................................................................................................................. 3
5 General Specifications ............................................................................................................................... 3
6 Remote On/Off ........................................................................................................................................... 4
7 Feature Specifications ................................................................................................................................ 4