BOP HIPWR 091719
3-31
FIGURE 3-10. SAVED SETUPS MENU
2. Use the
U
and
Y
keys to highlight the desired memory location; To erase a highlighted
memory location, press
#
. The list will show erased locations as
Empty
.
3. Press
!
to see the details stored in the highlighted location.
4. Once the details are displayed, use the
U
and
Y
keys to highlight the desired parameter.
NOTE: If a value to be saved is beyond the range of the unit, the value saved will be limited to
the maximum value. If the Mode is changed, the numerical values for the main and
protection channels must be revised accordingly.
•
To modify the parameter, press
!
. Highlight the desired choice from a list, or use the
keypad to enter a numeric value, then press
$
to save, or
%
to abort.
•
To exit without changing the parameter, press
%
.
5. Continue to modify parameters as described in step 4 above. When all parameters have
been modified, press
$
to save for power-up. Press
%
to exit without storing the
changes.
NOTE: If the message CHANGES NOT ALLOWED is displayed, the memory location has been
remotely locked (see PAR. A.12 for details).
6. After the changes have been saved, the unit returns to the Saved Settings screen, where
the saved settings can now be applied to the output by pressing
@
.
VOLTAGE
SOURCE
VOLTAGE
CURRENT
0.0000 0.0000
Summary of Contents for BOP-ME 1KW
