22
EN
Preparing for playback
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the "
CLIP
" indicator
will lights up. Adjust the input level.
1
Press the RCV MODE key on the remote control unit to
set it to the receiver control mode.
2
Press the SOUND key.
3
Use the MULTI CONTROL
@
/
#
(or the
@
/
#
keys) to select
"INPUT", and press the ENTER.
4
Use the MULTI CONTROL
%
/
fi
(or the
%
/
fi
keys) to
adjust the input level.
÷
The adjustment mode is displayed for approximately 20
seconds.
÷
The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
÷
You can store a separate input level for each input selector.
5
Press the SOUND key again to return to the input
indication.
Re-assignment of rear panel jacks
The assignment of the input selector positions to the digital audio and
component video input jacks can be changed as desired.
1
Press the SETUP key.
2
Use the MULTI CONTROL
@
/
#
(or the
@
/
#
keys) to
select "ASSIGN." on setup displays, and press the ENTER.
3
Use the MULTI CONTROL
@
/
#
(or the
@
/
#
keys) to
select "DIGITAL" or "COMPONENT", and press the ENTER.
1
"
DIGITAL
": Select to change the assignment of the digital
audio input jacks of the receiver.
2
"
COMPONENT
": Select to change the assignment of the
component video input jacks of the receiver.
3
"
EXIT
": Press the
ENTER
again to return to the main
setup displays.
Input selector position (
%
/
fi
)
1
"
DVD
"
2
"
V2
"
3
"
V1
"
4
"
AUX
"
When the "DIGITAL" has been selected:
Input selector position (
%
/
fi
)
1
"
DVD
"
2
"
V2
"
3
"
V1
"
Input jack selection (
@
/
#
)
1
"
CPNT1
"
2
"
CPNT2
"
When the "COMPONENT" has been selected:
Jack name
COAX2 (VIDEO 2)
OPT1 (VIDEO 1)
OPT2 (AUX)
COMPONENT VIDEO INPUT
IN1 (DVD)
COMPONENT VIDEO INPUT
IN2 (VIDEO 2)
COAX1 (DVD)
÷
It is not permitted to assign two input selector positions for
one input jack.
5
Repeat step
4
until you have assigned the desired jacks
to the desired input selector positions.
6
Press the ENTER again to return to the main setup
displays.
Use the following table for your memorandum.
Input jack
Input selector
Assigned input selector
Input jack selection (
@
/
#
)
1
"
COAX1
"
2
"
COAX2
"
3
"
OPT1
"
4
"
OPT2
"
4
Press the MULTI CONTROL
@
/
#
(or the
@
/
#
keys) to select
the input jack name and then press the MULTI CONTROL
%
/
fi
(or the
%
/
fi
keys) to select the input selector position.
