Kenwood TK-5710(H), Service Manual, Page: 11 / 124

11
TK-5710
(
B
)
/5710H
(
B
)
INSTALLATION
1. Front Panel Kit (KCH-14/15:Option)
1-1. Installing the KCH-14/15 front panel kit to the
transceiver
1. Remove the upper case and lower case of the trans-
ceiver.
2. Insert the lead wire with connector (W700) of the control
unit (X53-412) into the connector (CN1) of the KCH-14 or
KCH-15.
3. Install the KCH-14 or KCH-15 on the transceiver using the
four screws (
z
) supplied with the front panel kit.
Note:
Take care that the lead wire with connector (W700) is not
caught when fitting the KCH-14 or KCH-15 on the
transceiver. (You can install the panel upside down if
necessary to install the transceiver.)
4. Affixing the sheet (G11-4379-04) for the waterproof
(Fig.1-1-2).
(1) Remove the covering paper of the sheet (
x
).
(2) Affix the sheet while taking note of the position of the
three parts as shown in Fig.1-1-2 (
c
).
Firmly affix the sheet to the chassis by pushing the
double-coated tape with your fingers.
(3) Repeat step (2) to affix the sheet to the other side of
chassis.
Note:
The sheet cannot be reused. Affix a new sheet when you
removed the sheet.
5. Reassemble the upper case and lower case. (Refer to
page 24)
Note:
Take care that the sheet (G11-4379-04) is not peeled off
when installing the upper / lower case.
6. Connect the short plug to the accessory connector (9-pin)
on the rear of the transceiver.
1
1
KCH-14 or
KCH-15
W700
CN1
Transceiver
Fig. 1-1-1
1
2
3
4
5
6
7
8
9
10
Fig. 1-2
No. K29-5276-03 K29-5277-03 K29-5305-03
1 AN RCL CH1
2 D/A RPT CH2
3 DIM SCN CH3
4 HA SP CH4
5 HC SPM CH5
6 IC SQ AUX A
7 MON TA AUX B
8 OPT AUX C
9 OST EMG
10 PA No printing
■
No. K29-9353-13 K29-9354-03 K29-9356-03
1 2TN GPS PAG
2 AD STS SIT
3 AR TAC SRC
4 CLK TON No printing
5 FNC RES No printing
6 PBK IDV No printing
7 SCP KDL No printing
8 SEC TGR No printing
9 SEL No printing No printing
10 SES No printing No printing
1-2. Installing the accessory keytops to the front
panel kit
When a function is set by the programming software
(KPG-95D), the key legend can be changed by inserting the
accessory keytops into PF1 to PF9 of the KCH-15 (PF1 to
PF5:KCH-14). The accessory contains 60 keytops as shown
the table below.
Fig. 1-1-2
2
3
Affix the sheet while
taking note of the position
of the three parts.