TK-3178
(
L
)
9
1. Removing the FPC (J87-0033-05)
1) Remove the solder from the TX-RX unit using a solder
iron (
q
).
2) Peel the double-sided tape (
w
).
3) Remove the solder from the battery terminal block using
the solder iron (
e
).
Note:
You must replace the FPC and the double-sided tape
(4 x 7 mm) when replacing the volume or the selector.
1. 取下 FPC(J87-0033-05)
1) 用电烙铁从 TX-RX 单元上焊下焊锡 ( ① )。
2) 揭去双面胶带 ( ② )。
3) 用电烙铁从电池端子上焊下焊锡 ( ③ )。
注意 :
更换音量开关或选择器后，必须更换 F P C 和双面胶带
(4×7mm)。
.
:
@
2. Separating the Speaker Holder (J19-
5481-03) from the Control Unit
1) As in shown in the fi gure below, the speaker holder is at-
tached to the LCD cover with tab (
q
).
Use a pair of tweezers or similar instrument to lift the
speaker holder away from the control unit (
w
).
2. 从控制单元上拆下扬声器座 (J19-5481-03)
1) 如下图所示，扬声器座固定在带凸起的 LCD 盖上 ( ① )。
用一对镊子或类似的工具将扬声器座从控制单元中提出来
( ② )。
:
@
DISASSEMBLY FOR REPAIR /
维修拆卸
