20
TK-2107
TK-260
:K, K2
1. Jig (chassis) for adjustment (part number A10-
1392-03)
2. Use the jig as follows:
1. Insert the coaxial antenna connector into the jig.
2. Place the unit on the jig and fix it with 12 screws.
3. Solder the antenna terminal to the terminal of the unit.
Notes: Supply power from an external power supply.
Relay terminal: +
jig (chassis)
: –
( )
ADJUSTMENT FREQUENCY LIST
Destination
M3
CH
TX f (MHz)
RX f (MHz)
Center
220.00
Low
216.05
Hi
222.95
Remarks
• Connect the transceiver to the PC
• Send the channel data to the transceiver, then backup
the data.
• Program the adjustment frequencies which are in the
list, into the transciever.
Note : Remember to reload the channel data you backed up
after making the adjustments.
ADJUSTMENT
Adjustment point
TC201: Band-pass filter waveform adjustment
L212:
AF level adjustment
TC1:
Transmit lock voltage adjustment
TC2:
Receive lock voltage adjustment
TP2:
Band-pass filter test point
Foil Side View
ANT:
Antenna connector
CH:
Channel selector
SP:
Speaker jack
MIC:
Microphone jack
CV:
Lock voltage adjustment terminal
VR500: DQT waveform adjustment
VR501: DEV adjustment
Componennt Side View
Note : To fine tune the frequency when not
using a computer, adjust VR1.
MIC
ANT
VR500
VR501
VR1
IC403
CV
SP
MIC
CH
TC2
TC201
TC1
TP2
R225
L212
Coaxial antenna connector
JIG
Relay terminal
UNIT