key
hopper
feed tube
body
scroll
die*
securing nut
clamp ring of cutting assembly
cutting blade
spanner/pusher
cleaning tool
power unit
attachment outlet
locking screw
on/off switch
reverse switch
*Included in your pack is the
Maccheroni rigati die shown on the
illustration page. To purchase any of
the additional dies shown on the
back page of this booklet, please
call 0870 241 3653 or contact the
shop where you purchased the
attachment.
to assemble
1 Optional: for easier pasta making,
warm the body, die and ring nut in
hot water, then dry.
2 Release the locking screw by turning
anti clockwise
, then slide the
pasta maker body into the outlet.
3 Turn it both ways until it locks into
place. Then turn the locking screw
clockwise to secure.
4 Fit the scroll inside the body and
rotate until it engages with the
machine.
5 Fit the die.
6 Fit the securing nut and hand
tighten. (Don’t use the
spanner/pusher as this is to assist
with removal only).
●
Make sure the securing nut is almost
flush against the body of the
attachment.
7 Fit the hopper.
Optional:
The cutting assembly
can be fitted to the assembled pasta
maker to assist with cutting the
pasta into the desired lengths.
1 With the handle of the cutting blade
uppermost, unscrew the clamp ring
slightly. Place over the securing nut
and twist if necessary until fully
home on the attachment. The die
should fit flush with the front of the
cutting assembly.
2 Hold the edge of the cutting
assembly and at the same time
tighten the clamp ring by turning
away from you
.
Note
– Whenever you fit or remove
the cutting assembly, always hold
the edge of the assembly in one
hand and twist the clamp ring with
the other.
to use your pasta maker
1 Make your pasta mix following a
recipe supplied.
●
Don’t make the mix too dry as it
could break your pasta maker or
machine. It should resemble coarse
breadcrumbs or a coarse crumble
texture. The particles should be
separate but if squeezed together it
should form a clump which bonds
together.
2 Switch on.
3 Place some of the mix onto the
hopper. Feed a small amount of mix
into the feed tube at a time. Allow
the scroll to clear before continuing.
If the feed tube becomes clogged
use the end of the spanner/pusher
handle to push the mix onto the
scroll (don’t use anything other than
the spanner handle and don’t push
too hard). Never let the feed tube fill
up.
4 When the pasta is long enough,
move the handle on the cutting
assembly back and forth to cut the
pasta into the desired length.
Alternatively if the cutting assembly is
not fitted use a knife to cut the pasta.
3
