Kenwood LZ-601, Instruction Manual

Page: 4 / 44

4
Installation
- English
• If your car's ignition does not come with an ACC position, connect the ignition cables to a
power source that can be turned on and off with the ignition key. If you connect the ignition
wire to a power source that receives a constant voltage supply, as with battery cables, the
battery may die.
• If the fuse blows, first make sure that the cables have not caused a short circuit, then
replace the old fuse with one with the same rating.
• Do not let unconnected cables or terminals touch metal on the car or anything else
conducting electricity. To prevent short circuits do not remove the caps from unused
terminals or from the ends of the unconnected cables.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car
are working properly.
• Insulate unconnected cables with vinyl tape or other similar material.
• Thoroughly wipe away oil and other dirt from the installation surface.
Please avoid installation on uneven surfaces.
2
CAUTION
Connection
– +
VIDEO OUT
(3A)
Accessory
1
Ignition cable (Red)
ª
12V
Ignition key switch
Car fuse box (Main fuse)
ACC
Ground cable (Black)
·
(To car chassis)
Battery
Monitor Unit
Video input
Fuse
LZ-601_E 02.2.15 10:37 AM Page 4