3
Installation
English -
Accessories
1
2
3
(Ø4 x 12 mm)
To prevent short circuits, remove the key from the ignition and disconnect the
·
terminal
of the battery.
Make the proper input and output cable connections for each unit.
Connect the wiring harness cables in the following order: ground, ignition.
Connect the wiring harness connector to the unit.
Install the unit in your car.
Reconnect the
·
terminal of the battery.
• This product is intended for use with 12V DC negative ground power only. Do not connect it
to any other power supply
• To prevent shorting, disconnect the battery cable from the negative terminal of the battery
during installation.
• Be sure to firmly stabilise this product. Do not install it in a location which is not stable.
• Follow the installation and wiring procedures described in this manual. Improper wiring or
modified installation can not only result in malfunction or damage to the unit but may also
result in an accident.
•
Do not install the unit in the following locations.
• A location which interferes with the operation of the air bag system.
• A location which is not made of plastic.
\
Installing on leather, wood or cloth may damage the surface.
• A location subject to direct sunlight, subject to the air from the air conditioner, or subject
to moisture or high temperature.
\
This may cause deformation of the monitor unit.
•
Be sure to use the supplied screws for installation.
Using screws longer than those supplied may destroy parts inside the unit causing it to
smoke. Using screws shorter than those supplied may cause the unit to come looks from the
installation bracket.
• If you are not going to install the unit using the supplied monitor stand, be sure to use a
commercially available monitor stand. (Mounting holes for such a stand are located on the
bottom of the monitor unit.)
2
WARNING
6
5
4
3
2
1
Installation Procedure
LZ-601_E 02.2.15 10:37 AM Page 3
Summary of Contents for LZ-601
Page 44: ......