To Fit And Use Your
Splashguard
Refer to Illustrations
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
–
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the
underside of the mixer head until fully
located. The hinged section should be
positioned as shown.
4 Insert required tool.
5 Lower the mixer head.
l
During mixing, ingredients can be
added directly to the bowl via the
hinged section of the splashguard.
l
You do not need to remove the
splashguard to change tools.
6 Remove the splashguard by raising
the mixer head and pushing it down.
Tool Adjustment
Refer to Illustrations
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
K-beater & Whisk
The tools are set to the correct height
for the bowl supplied in the factory and
should not require adjustment.
However, if you wish to adjust the tool
use a suitable sized spanner:
TYPE KVC65 = 15mm
TYPE KVL65 = 19mm
Then follow the instructions below:
1 Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the
clearance needs to be adjusted,
raise the mixer head and remove the
tool. Ideally the whisk and K-beater
should be
almost
touching the
bottom of the bowl.
4 Using a suitable spanner loosen the
nut sufficiently to allow adjustment
of the shaft. To lower the tool closer
to the bottom of the bowl, turn the
shaft anti-clockwise. To raise the tool
away from the bottom of the bowl
turn the shaft clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower
the mixer head. (Check its position
see points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once
this is acheived tighten the nut
securely.
l
Note: Spanner shown is for
illustration purpose only.
Dough Tool
This tool is set at the factory and should
require no adjustment.
To Fit and Remove Head
Cover
Refer to Illustrations
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
–
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
1 Remove the slow speed and high
speed outlet covers.
2 With the retention clip pressed in, lift
up the head cover and slide forward.
3 To fit an alternative head cover, insert
the pegs on the end of the head cap
into the two holes on the slow speed
outlet.
4 Whilst pressing the retention clip,
push the head cover down into place
on the mixer head.
5 Replace slow speed and high speed
outlet covers.
Care & Cleaning
l
Always switch off and unplug before
cleaning.
l
A little grease may appear at the
slow speed outlet
2
when you first
use it. This is normal – just wipe it off.
Power Unit, Outlet Covers and Head
Cover
l
Wipe with a damp cloth, then dry.
l
Never use abrasives or immerse in
water.
8
9
