1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the underside of the mixer head
���
until fully located. The hinged section should be positioned as shown.
4 Insert required tool.
5 Lower the mixer head.
●
During mixing, ingredients can be added directly to the bowl via
the hinged section of the splashguard
���
.
●
You do not need to remove the splashguard to change tools.
6 Remove the splashguard by raising the mixer head and sliding it
down.
troubleshooting
problem
●
The whisk or K-beater knocks against the bottom of
the bowl or isn’t reaching the ingredients in the bottom
of the bowl.
solution
●
Adjust the height. Here’s how:
1 With the mixer switched off, insert the beater or whisk and lower
the mixer head. Check the clearance between the tool and
the bottom of the bowl
���
. Ideally the tool should be almost
touching the bottom of the bowl.
2 If the clearance needs to be adjusted, raise the mixer head and
remove the tool.
3 Using a suitable spanner loosen the nut sufficiently to allow
adjustment of the shaft
���
. To lower the tool closer to the
bottom of the bowl, turn the tool shaft anti-clockwise.
To raise the tool away from the bottom of the bowl turn
the shaft clockwise.
4 Tighten the nut.
5 Fit the tool to the mixer and lower the mixer head. Check its
position (see point 1).
6 Repeat the above steps as necessary until the tool is set
correctly. Once this is achieved tighten the nut securely.
Note:
●
No adjustment of the dough hook is necessary.
problem
●
The mixer stops during operation.
solution
●
If for any reason power to the mixer is interrrupted and the
machine stops working, turn the speed switch to the off position,
wait a few seconds and then re-select the speed. The mixer
should resume operating straight away.
to fit and use your splashguard
���
���
���
5
���
