Kenwood KDW60S12, Installation Instructions Manual

Page: 11 / 36

11
installation
8. Make sure your plumbing is suitable for
use with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS
using the new water supply hose. OLD
HOSE SETS MUST NOT BE RE-USED.
The water pressure from the water mains
needs to be at a minimum of 0.04 MPa and
a maximum of 1.00MPa.
• Connect one end of the water supply
hose to your dishwasher, and then
connect the other end of the hose to
your water mains. Please ensure the
black rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
• Do not bend your drain hose.
7. Position the dishwasher next to a water
tap and a drain. Ensure the water inlet and
drain hoses are not kinked or squashed.
The unit must not stand on the mains
cable.
ON
OFF
You may use a Y-adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable for cold
water mains. A Y-adaptor is available
from most DIY stores.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance
if required.
safety water supply hose