operating instructions
GB-1
starting a wash cycle
Please follow the steps below to start a wash cycle.
Ensure the unit is connected to the mains power and the water supply
is on (water pressure between 0.03MPa and 1.00MPa).
Open the door. Pull out the dishwasher basket, load the dishes and
push the basket back.
Pour the detergent into the detergent slot.
Close the dishwasher door. A click sound should be heard when the
door is closed correctly. Do not slam the door.
Press the ON/OFF button.
Select the wash cycle programme based on the loading and soil re-
quirements. Please refer to the “Wash Cycle Table” (page 15).
The power indicator light will illuminate, and the display window will
show the selected washing programme.
The washing cycle will begin shortly.
NOTE:
If you open the dishwasher door during the washing cycle and
then close it, the dishwasher will continue the current washing programme
after 5 seconds.
However, if the door is not closed correctly after 1 min-
ute, the dishwasher will make an audible sound at 1 minute intervals.
The display window will show the default washing programme when it is
switched on. If you select the same washing programme for 3 times, it will
automatically become the default washing programme.
changing a programme
To change the programme if the washing cycle has already started, follow
the steps below.
Press PAUSE/START button to stop the programme. Open the door
slightly to check if the detergent is dissolved. This will depend on how
long the washing cycle was running for.
If the detergent is dissolved, we suggest you to allow the wash cycle
to complete.
If the detergent has not yet dissolved, press ON/OFF button to cancel
the programme. Press ON/OFF button again to restart the unit. You
can then press the required new programme button and press pause/
start button again. The unit will start the new washing cycle shortly.
1.
.
3.
4.
5.
6.
7.
8.
1.
.
3.
Kenwood KDW4TTSL_IB_GB_090828.in21 21
28/08/09 12:03:03 PM
