operating instructions
GB-17
adjusting rinse aid reservoir
The rinse aid reservoir has six settings. Both the recommended
setting and the factory setting is “4.” (Fig 2b on page 16)
If the dishes are not drying properly or are spotted, adjust the dial
to the next higher number until your dishes are spot-free.
adding salt
If the water in your area is hard,
deposits will form on your dishes and
utensils. As such, this appliance
contains a salt reservoir for you to
reduce the hardness of the water.
Please follow the steps below to pour
the salt into the salt reservoir and it
must be set to correspond to the
water hardness level in your area.
1.
Remove the lower basket and
unscrew the reservoir cap. (Fig 1)
2.
Fill the reservoir with
approximately 500ml of water
(first use only).
3.
Place the funnel provided over the
salt reservoir. (Fig 2)
4.
Pour in approximately 1.2kg of
dishwasher salt depending on the
brand used.
5.
Clean any excess salt from around
the reservoir opening and then
screw the cap on again firmly.
6.
Run the “rapid” wash programme
immediately (without any crockery
in the dishwasher) to remove any
traces of salt from the
compartment.
OPEN
open
open
open
1
2
Kenwood KDW12SL3A_IB_100924_Zell.indd 17
24/09/2010 10:39 AM
