48
|
KDC-XBT8013U/ KDC-XBT8013UL/ KDC-X7013U/ KDC-X7013UL
Troubleshooting Guide
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• No output from the subwoofer.
• Cannot set up the subwoofer position of Manual
position setting.
▲
• <Subwoofer output> of <Basic Operation> (page 4)
is not set to On.
• The Dual zone function is enabled.
☞
<Audio
Setup> (page 27)
!
• Cannot set up the subwoofer phase.
▲
The Low Pass Filter is set to Through.
☞
<X’Over
setting> (page 29)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear speakers.
▲
The Dual zone function is disabled.
☞
<Audio
Setup> (page 27)
!
• Cannot register a security code.
• Cannot set up Display.
▲
<Demonstration mode Setting> (page 26) is not
turned off.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The Touch Sensor Tone does not sound.
✔
The preout jack is being used.
☞
The Touch Sensor Tone cannot be output from
the preout jack.
?
The illumination flashes when the knob or button
is operated.
✔
This is the key illumination effect.
☞
You set this effect in “MENU” > “ILM Effect” of
<Function Control> (page 6).
?
The key illumination effect brought about in
conjunction with the sound volume is small.
✔
The key illumination effect may be insufficient
depending on the sound volume and sound
quality.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
Disc source
?
The specified disc does not play, but another one
plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD, referring to the CD cleaning of the
section on <Handling CDs> (page 3).
✔
The disc is loaded in a different slot from that
specified.
☞
Eject the disc magazine and check the number
for the specified disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 3).
✔
The recording condition is bad.
☞
Record the media again or use another media.
B64-4418-00_00_en.indd 48
09.1.13 10:34:27 AM
