Some functions of this unit may be disabled by
some settings made on this unit.
!
Cannot switch to Aux source.
▲
• AUX is not turned on.
☞
<Built-in Auxiliary input
Setting> (page 26)
• AUX cannot be used when the KCA-iP200 is
connected.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
▲
• <Subwoofer Output> (page 10) is not set to On.
• The Dual zone function is enabled.
☞
<Audio
Setup> (page 9)
!
• Cannot set up the high pass filter.
• Cannot set up the Fader.
▲
The Dual zone function is enabled.
☞
<Audio
Setup> (page 9)
!
Cannot set up the subwoofer phase.
▲
Low pass filter is set to Through.
☞
<Audio Setup>
(page 9)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear speakers.
▲
The Dual zone function is disabled.
☞
<Audio
Setup> (page 9)
!
No Audio control effect on AUX.
▲
The Dual zone function is enabled.
☞
<Audio
Setup> (page 9)
!
• Cannot register a security code.
• Cannot set up Display Illumination Control.
▲
<Demonstration mode Setting> (page 27) is not
turned off.
!
Cannot play audio files.
▲
<CD Read Setting> (page 26) is set to "2".
!
Cannot File select.
▲
The Scan play or Random play function is enabled.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The Touch Sensor Tone doesn’t sound.
✔
The preout jack is being used.
☞
The Touch Sensor Tone can’t be output from the
preout jack.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
☞
Connect the wire correctly, referring to the
section on <Connecting Wires to Terminals>
(page 31).
Disc source
?
The specified disc does not play, but another one
plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD.
✔
The disc is loaded in a different slot from that
specified.
☞
Eject the disc magazine and check the number
for the specified disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 6).
✔
The audio file is broken or not supported.
☞
Damaged and unsupported files are skipped.
✔
The recording condition is bad.
☞
Record the media again or use another media.
Troubleshooting Guide
34
|
English
B64-3616-00̲00̲English.indd 34
B64-3616-00̲00̲English.indd 34
06.12.11 8:46:58 AM
06.12.11 8:46:58 AM
