English
|
25
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main
unit so that it does not fall off.
1
Refer to the section 'Removing the hard rubber
frame' (page 26) and then remove the hard
rubber frame.
2
Drop open the faceplate by pressing the Release
button.
3
Tighten the screws (ø2.6 × 12 mm) (Accessory
5
) in the holes shown on the diagram.
Accessory
5
4
Tighten the screws (ø2 × 4 mm) (Accessory
6
) in
the holes shown on the diagram.
Accessory
6
5
Tighten the screws (ø2 × 6 mm) (Accessory
7
) in
the holes shown on the diagram.
Accessory
7
• Never insert the screws in any other screw hole than the
one specified. If you screw them in another hole, it will
contact and may cause damage to the mechanical parts
inside the unit.
KDC-3025̲K̲2694̲U.S̲r2.Indd 25
03.10.2, 3:32:13 PM
Summary of Contents for KDC-3025
