8
Programming the Pyramid 2016 (Continued)
The figures below shows how a typical RasTrac I/O processor will be set up when
connected to a 2016 and TK-x80 series radio. To access the I/O configuration, select the
Edit
pull down menu from the RasTrac I/O Processor. From the
Input/Output
Configuration
screen, select the
Protocol
to be
PYRAMID
. Then click
Properties
to
configure the 2016.
Depending on the version of the Rastrac IOP you are using, your IOP setup screen may
look like either of these examples.
Set COR and PTT to HI
Set PTT Delay to
0-Trunking if applicable.
Console and
Speed will vary
with your
application.
Note:
Console
needs to match
programming
the 2012.
Note:
Console
needs to match
programming
the 2012.
Set COR and PTT to HI
Set PTT Delay to
0.5 Seconds. This is the delay
after the handshake if trunking
is selected. If using
conventional, this is the PTT
lead in delay before sending
data.
Console and
Speed will vary
with your
application.
Select Trunking if
you are using a
Trunking Radio
