9
1 Press and hold the PTT switch and
Monitor key, then turn the power
ON.
•
Continue to hold the PTT switch
and Monitor key until the LED
lights orange, then release the
keys.
2 Press the Monitor key.
•
The LED changes from orange to
green and a beep sounds. The
transceiver is now in QT tone setup
mode.
3 Rotate the Channel selector to
choose the channel you want to
set up.
■
QT Tone Setup
Note:
◆
Refer to the signalling codes listed in the table on page 8.
◆
When selecting a single digit number (0 ~ 9), always use 2 digits
(00 ~ 09).
◆
When you are confirming the selected signalling number, there
is a short pause between the 10’s digit and the 1’s digit.
The transceiver will exit the setup mode if no
operation is performed within 5 seconds.
1
3
5
7
9
11
13
15
1
3
5
7
9
11
13
15
