7
OPERATING BASICS
1 Switch ON the transceiver by turning
the Power switch/ Volume control
clockwise.
•
A beep sounds.
2 Adjust the volume by pressing and
holding the Monitor key, then rotating
the Power switch/ Volume control.
3 Rotate the Channel selector to
choose your desired channel.
•
When you receive an appropriate
signal, you will hear audio from the
speaker.
4 To make a call, press and hold the
PTT switch, then speak into the
microphone using your normal
speaking voice.
•
Hold the microphone approximately
1.5 inches (3 to 4 cm) from your lips.
5 Release the PTT switch to receive.
Note:
◆
The channel in use may have been programmed
with a signalling code. Refer to “QUIET TALK
(QT)” on page 8.
◆
When the battery pack voltage becomes too low,
transmission will stop and the LED will blink red.
Refer to “Low Battery Warning” on page 15.
1
3
5
7
9
11
13
15
1
3
5
7
9
11
13
15
1
3
5
7
9
11
13
15
