2
PREPARATION
1
Match the four grooves
of the battery pack with
the corresponding
guides on the back of
the transceiver.
2
Slide the battery pack
along the back of the
transceiver until the
release latch on the
base of the transceiver
locks.
3
To remove the battery
pack, pull back on the
release latch and slide
the pack away from the
transceiver.
■
Installing/ Removing the Battery Pack
◆
Do not recharge the battery pack if it is already fully charged.
Doing so may cause the life of the battery pack to shorten or
the battery pack may be damaged.
◆
After recharging the battery pack, disconnect it from the
charger. If the charger power is reset (turned on after being
turned off), recharging will start again and the battery pack
will become overcharged.
◆
Do not short the battery terminals or dispose of the battery
by fire.
◆
Never attempt to remove the casing from the battery pack.
