![Kenwood DPX-MP4100 Instruction Manual Download Page 8](http://html.mh-extra.com/html/kenwood/dpx-mp4100/dpx-mp4100_instruction-manual_188578008.webp)
8
|
English
General features
4
Adjust the Detail Audio item
Turn the [VOL] knob.
Bass level
Adjustment Item
Display
Range
Bass Center Frequency
"BasF"
40/50/60/70/80/100/
120/150 Hz
Bass Q Factor
"BasQ"
1.00/1.25/1.50/2.00
Bass Extend
"B EX"
ON/OFF
Middle level
Adjustment Item
Display
Range
Middle Center Frequency
"MidF"
0.5/1.0/1.5/2.0 kHz
Middle Q Factor
"MidQ"
1.0/2.0
Treble level
Adjustment Item
Display
Range
Treble Center Frequency
"TreF"
10.0/12.5/15.0/17.5 kHz
5
Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
⁄
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [VOL] and [ATT] buttons.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item
Display
Range
Front High Pass Filter
"HPF"
Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter
"HPR"
Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter
"LPF"
50/60/80/100/120/Through Hz
Subwoofer Phase
"PHAS"
Normal (0°)/ Reverse (180°)
Volume offset
"V-OFF"
–8 — ±0 (AUX: -8— +8)
Loudness
"LOUD"
ON/OFF
Dual Zone System
"2ZON"
ON/OFF
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones
during low volume. (Only the low tone is
compensated for when the tuner is selected
as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 23).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 7).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the internal
auxiliary input.
5
Exit Audio Setup mode
Press any button.
Press a button other than the [VOL] knob, [SRC],
[
0
] and [ATT] button.
Audio Setup
Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
B64-3609-00̲English̲r5.indd Sec1:8
B64-3609-00̲English̲r5.indd Sec1:8
06.12.6 3:00:37 PM
06.12.6 3:00:37 PM