26
|
English
Some functions of this unit may be disabled by
some settings made on this unit.
!
Cannot switch to Aux source.
▲
AUX is not turned on.
☞
<Built-in Auxiliary input
Setting> (page 20)
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
▲
• Preout is not set to subwoofer.
☞
<Switching
preout> (page 18)
• <Subwoofer Output> (page 8) is not set to On.
!
Cannot set up the subwoofer phase.
▲
Low pass filter is set to Through.
☞
<Audio Setup>
(page 7)
!
Cannot play audio files.
▲
<CD Read Setting> (page 20) is set to "2".
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The Touch Sensor Tone doesn’t sound.
✔
The preout jack is being used.
☞
The Touch Sensor Tone can’t be output from the
preout jack.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
☞
Connect the wire correctly, referring to the
section on <Connecting Wires to Terminals>
(page 24).
Disc source
?
The specified disc does not play, but another one
plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD.
✔
The disc is loaded in a different slot from that
specified.
☞
Eject the disc magazine and check the number
for the specified disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 4).
✔
The recording condition is bad.
☞
Record the media again or use another media.
Troubleshooting Guide
B64-3612-00̲00̲M̲English.Indd 26
B64-3612-00̲00̲M̲English.Indd 26
06.12.22 1:32:10 PM
06.12.22 1:32:10 PM
