70
CONNECTION/INSTALLATION
CONNECTION/INSTALLATION
Connecting the GPS antenna
Connect the GPS antenna (
0
) to the GPS terminal.
• To install the GPS antenna, fix the metal plate
(
-
) firmly on the dashboard, then place the GPS
antenna (
0
) on the metal plate (
-
).
– Clean the dashboard or other surface
beforehand.
– Install the GPS antenna (
0
) inside of the car, as
horizontally as possible to allow easy reception
of the GPS satellite signals.
– You can bend the metal plate (
-
) to conform to
a curved surface, if necessary.
0
-
0
• Depending on the type of car, reception of the
GPS satellite signals might not be possible with an
internal installation.
• Install this GPS antenna in an area away from any
antennas that are used with CB radios or satellite
televisions.
• The GPS antenna should be installed at a position
that at least 30 cm (12 inches) from mobile phone
or other transmitting antennas.
• The above types of communication may interfere
with signals from the GPS satellite.
• Painting the GPS antenna with (metallic) paint
may cause reduced performance.
Removing the unit
Removing the trim plate
1
Engage the catch pins on the extraction
key (
4
) and remove the two locks on the
lower part. Lower the frame and pull it
forward.
4
2
Remove from the upper two catches.
• The frame can be removed from the top side in
the same manner.
Removing the unit
1
Remove the trim plate. (See the left
column.)
2
Insert the two extraction keys (
4
), then
pull them as illustrated so that the unit can
be removed.
4
• Be careful to avoid injury from the catch pins on
the extraction key.
DDX̲High̲K.indb 70
2015/04/15 16:16
