Your Kenwood Can Opener can be
used to open a variety of domestic can
shapes and sizes. In addition the
CO600 incorporates a bottle opener
and a knife sharpening facility.
key
햲
bottle opener
햳
drive wheel
햴
magnet
햵
lever
햶
cutter blade
햷
guide pin
햸
knife sharpener
햹
cord stowage
using your table top can
opener
1 Plug the appliance into the power
supply.
2 Lift the lever to the open position.
3 Hold the can with the top rim resting
under the metal guide pin and the
can resting on the drive wheel
���
.
4 Press the lever lightly down to start
the motor. The self-starting blade will
then pierce the can and commence
cutting
���
.
5 The can will be held fixed in position
with the magnet resting against the
lid. Large or wide cans may require
extra support from the user.
6 Once the can is open, the motor will
automatically stop, retaining the can
and lid safely in place.
7 To remove, lift the lever whilst
holding the can.
8 With the exception of aluminium
cans, the lid will be retained by the
magnet
���
.
9 For tidiness, any unwanted length of
cord can be stowed inside the
appliance.
10 Do not use the appliance to open
ring-pull cans.
using the bottle opener
When opening tall bottles, the unit
should be used towards the edge of
a work top.
1 Position the bottle with the cap under
the front rim of the bottle opener
���
.
2 Push down the bottle to remove the
cap whilst steadying the unit with
one hand.
using the knife
sharpener
1 With the can opener sideways on,
place the knife into one of the
recesses.
2 Gradually draw it towards yourself.
Then place the knife in the other
recess and repeat. Take care not to
allow the knife to cut into the body
of the can opener
���
.
3 Repeat this cycle several times in
order to sharpen the knife
satisfactorily.
NOTE: Knives without a serrated
edge, preferably carbon steel are
most suitable for sharpening.
care and cleaning
1 Disconnect the appliance by
switching off and removing the plug
from the power supply.
2 Lift the lever fully and withdraw the
assembly from the can opener
���
.
3 Wash the lever in hot sudsy water
and dry thoroughly. Dishwashing is
not advised.
4 Replace the lever in the body
5 Wipe over the body with a damp
cloth and dry thoroughly.
service & customer care
l
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
l
If you experience any problems with
the operation of your appliance,
before requesting assistance visit
www.kenwoodworld.com.
l
Please note that your product is
covered by a warranty, which
complies with all legal provisions
concerning any existing warranty
and consumer rights in the country
where the product was purchased.
3
