English
|
5
• Do not route wiring in places that get hot, such as
near the heater outlet. If the insulation of the wiring
melts or gets torn, there is a danger of the wiring
short-circuiting to the vehicle body.
• When replacing the fuse, be sure to use only fuse of
the rating prescribed on the fuse holder.
• To minimize noise locate the TV antenna cable, radio
antenna cable and RCA cable as far away from each
other as possible.
• Lay the cords by avoiding high-temperature areas.
Use corrugated tubes for wiring inside the engine
room. If a cord contacts a high-temperature area of
the vehicle, the coating may melt and cause short-
circuiting, which may lead to a fire or electric shock
hazard.
Accessories
Camera (3.0 m)..........1
Power cord (6.0 m
[1]
)..........1
1
4
Power unit..........1
FUSE 2A
ACC
Camera bracket..........1
Screw (M3 × 5 mm)..........2
Camera bracket clamping screw
(Ø3 × 8 mm)..........1
Grommet..........1
Band..........1
[1] Including the power unit
Before Use/ Installation Procedure
WARNING
• If you connect the ignition wire (Red) to the car
chassis (Ground), you may cause a short circuit, that
in turn may start a fire. Always connect those wires
to the power source running through the fuse box.
• Do not cut out the fuse from the ignition wire (Red).
The power supply must be connected to the wires
via the fuse.
CAUTION
• If your car’s ignition does not have an ACC position,
connect the ignition wires to a power source that
can be turned on and off with the ignition key. If you
connect the ignition wire to a power source with a
constant voltage supply, as with battery wires, the
battery may die.
• If the fuse blows, first make sure the wires aren’t
touching to cause a short circuit, then replace the
old fuse with one with the same rating.
• Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not
remove the caps on the ends of the unconnected
wires or the terminals.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Install so that it does not obstruct the rear field of
view.
• Install so that it does not protrude from the side of
the car.
• Do not perform installation in rain or fog.
• When humidity is high, dry the surface to which the
unit is to be attached before installing.
• Moisture on the attachment surface reduces
adhesive strength, which may lead to the unit
coming off.
• Do not attach the camera bracket to areas on the car
body treated with fluorocarbon resin, or glass.
• May result in the rear view camera falling off.
- Do not apply water to the unit.
- Do not expose the unit to rain.
- Do not subject the camera to unnecessary force.
- Thoroughly clean where tape is used for sticking
on the unit.
• Refer to the Instruction’s manual for details on
connecting the other units, then make connections
correctly.
• Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
• Route and secure all wiring so it cannot touch any
moving parts, such as the gear shift, handbrake and
seat rails.
B5A-3444-00_CMOS-740HD.indb 5
2019/12/13 17:52
