Kenwood CKB 300, Instructions For Use Manual

Page: 17 / 32

17
Fig. 4.3
A
U
T
O
Fig. 4.4
ELECTRONIC CLOCK
(fig. 4.2)
The programmer is equipped with an
electronic clock with an illuminated dis-
play which indicates hours and minutes.
Upon immediate connection of the oven
or after a power cut, three zeros will
flash on the programmer display.
To set the correct time of day it is neces-
sary to push the
button and then the
or button until you have set the
correct time (fig. 4.2).
Or push the two buttons
simul-
taneously and at the same time push the
or button.
Note: If the clock is reset it deletes any
previously set programs
ELECTRONIC TIMER
The timer consists only of a buzzer
which may be set for a maximum period
of 23 hours and 59 minutes.
If the AUTO symbol is flashing push the
button.
To set the time, push the button and
the or until you obtain the desired
time in the display panel (fig. 4.4).
Once set, the time will appear on the
panel and the
symbol will be lit.
The countdown will start immediately and
may be seen at any time on the panel by
simply pressing the button
.
At the end of the time, the symbol will
disappear and the buzzer will sound
continuously for approximately 7 min-
utes or until a button is pressed (not the
/
buttons). After a short time the
display will revert back to the time of
day.
SETTING THE FREQUENCY OF THE
AUDIBLE SIGNAL
The buzzer has 3 different tones and
can be changed by pressing the
but-
ton, but only when the time of day is dis-
played.
NORMAL COOKING WITHOUT THE
USE OF THE PROGRAMMER
To manually use the oven, without the aid
of the programmer, it is necessary to can-
cel the flashing AUTO by pushing the but-
ton (AUTO will be switched off and the
symbol
will illuminate - Fig. 4.3).
Attention: If the AUTO is lit (which means
a cooking program has already been set),
push the button
to cancel the program
and return to manual operation.
If the oven is switched on, you must
switch off manually.