34
Fig. 9.1
9 - INSTALLATION
LEVELLING
The cooker is equipped with 4 levelling
feet which must be fitted to the base of the
cooker in the following manner:
•
Place the cooker on its back as shown
in the figure 9.2.
•
Screw the 4 leveling feet to the cooker .
•
Stand the cooker and levelling it by
screwing or unscrewing the feet with
a spanner .
Fig. 9.2
This cooker has class “2/1” overheating protection so that it can be installed next
to a cabinet.
If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a
gap of at least 200 mm must be left between the side of the cooker and the furniture .
The walls and kitchen furniture surrounding the appliance must be made of non-flammable
material . The veneered synthetical material and the glue used must be resistant to a
temperature of 90°C in order to avoid ungluing or deformations . It is recommended that
a 10 mm gap to each side is made if the adjacent kitchen furniture is made of a plastic
laminate wrap .
Curtains must not be fitted immediately behind appliance or within 500 mm of the sides.
It is essential that the cooker is positioned as stated below .
We do not recommend the
cooker is located on a plinth .
If this is unavoidable, it will
be necessary to provide
safety measures to prevent
the appliance falling off .
The cooker must be
installed by a suitably
qualified technician and
in compliance with local
safety standards.
450 mm
200 mm
500 mm
650 mm
Summary of Contents for CK 232 DFA
Page 25: ...25 S F C T A B S T Fig 8 1 Fig 8 2 Fig 8 3 Fig 8 4 Fig 8 5 ...
Page 46: ...46 ...
Page 47: ...47 ...
